Daewoo Matiz since 1997 of release
1. The general data
2. Maintenance service
3. The engine
4. Transmission
5. A running gear
6. A steering
7. Brake system
7.1. The design description
7.2. Diagnostics of brake system
7.3. Removal and installation of knots of brake system
7.3.1. Brake hoses
7.3.2. The stoplight switch
7.3.3. A brake pedal
7.3.4. The main brake cylinder
7.3.5. A tank of a brake liquid
7.3.6. A pressure regulator
7.3.7. The gauge of level of a brake liquid
7.3.8. The vacuum amplifier and its hose
7.3.9. A support of a forward brake
7.3.10. A brake disk
7.3.11. A drum of the back brake mechanism
7.3.12. The wheel brake cylinder of the back brake mechanism
7.3.13. A protective casing of a back brake
7.3.14. The lever of a lay brake
7.3.15. A cable of a lay brake
7.4. Replacement brake колодок
7.5. Repair of knots of brake system
8. Systems of heating, ventilation and air-conditioning
9. A body electric equipment
10. A body
11. Schemes электроборудования
 









7-3-4-glavnyjj-tormoznojj-cilindr.html

7.3.4. The main brake cylinder

Removal
Remove a pressure regulator.
Remove the main brake cylinder in a following order:

Fig. 7.14. An arrangement of an electric socket (1) and unions (2) fastenings of brake tubes to the main brake cylinder




- Disconnect an electric socket 1 (fig. 7.14);
- Mark the brake tubes approaching to the main brake cylinder;
- Put pure rags under the main brake cylinder for gathering of the leaked brake liquid;
- Turn out unions 2 and disconnect from the main brake cylinder brake tubes;
- Stoppers close opened apertures of the main brake cylinder for prevention of leak of a liquid or its pollution;

Fig. 7.15. An arrangement of nuts (1) fastenings of the main brake cylinder




- Turn away a nut 1 (fig. 7.15) fastenings of the main brake cylinder and remove it from the car.

The prevention
The brake liquid dissolves a paint and plastic. Therefore at liquid hit on a paint and varnish covering of the car wash out its considerable quantity of water.

Installation
Establish the main brake cylinder and fix its nuts, having tightened their moment 16 Нм.
Connect to the main brake cylinder and fix brake tubes, having tightened unions the moment 16 Нм.
Connect an electric socket.
Establish a pressure regulator.
Pump over brake system.



To return back
7.3.3. A brake pedal
On the following page
7.3.5. A tank of a brake liquid