Daewoo Matiz since 1997 of release
1. The general data
2. Maintenance service
3. The engine
4. Transmission
5. A running gear
6. A steering
7. Brake system
7.1. The design description
7.2. Diagnostics of brake system
7.3. Removal and installation of knots of brake system
7.3.1. Brake hoses
7.3.2. The stoplight switch
7.3.3. A brake pedal
7.3.4. The main brake cylinder
7.3.5. A tank of a brake liquid
7.3.6. A pressure regulator
7.3.7. The gauge of level of a brake liquid
7.3.8. The vacuum amplifier and its hose
7.3.9. A support of a forward brake
7.3.10. A brake disk
7.3.11. A drum of the back brake mechanism
7.3.12. The wheel brake cylinder of the back brake mechanism
7.3.13. A protective casing of a back brake
7.3.14. The lever of a lay brake
7.3.15. A cable of a lay brake
7.4. Replacement brake колодок
7.5. Repair of knots of brake system
8. Systems of heating, ventilation and air-conditioning
9. A body electric equipment
10. A body
11. Schemes электроборудования
 









7-3-9-support-perednego-tormoza.html

7.3.9. A support of a forward brake

Removal

Preventions
At work brake колодок the brake dust containing asbestos, unhealthy is formed. Therefore at clearing brake колодок do not use compressed air and do not inhale a dust.
For clearing of brake mechanisms use only a special cleaner of brakes.
Necessarily replace supports in steam even if one support has failed only.


Tighten a lay brake and block back wheels an emphasis.
Ослабьте nuts of fastening of a forward wheel. Lift a forward part of the car and establish on support. Remove a forward wheel.

Fig. 7.26. An arrangement of a hollow bolt (1) fastenings of a brake hose and bolts (2) fastenings of a support in gathering to a rotary fist




Turn out a hollow bolt 1 (fig. 7.26) fastenings of a brake hose to a support. For an exception вытекания a brake liquid close an aperture of a brake hose a stopper or a piece of a rubber hose of suitable diameter. If the support acts in film for access to other components, do not disconnect from it a brake hose.
Turn out bolts of 2 fastenings of a support in gathering and remove it from the car.
Installation
Establish a support in gathering and fix bolts to a rotary fist, having tightened their moment 95 Нм.
Connect a brake hose and fix its hollow bolt, having tightened its moment 25,5 Нм.
Establish forward wheels.
Pump over brake system.



To return back
7.3.8. The vacuum amplifier and its hose
On the following page
7.3.10. A brake disk