Daewoo Matiz since 1997 of release
1. The general data
2. Maintenance service
3. The engine
4. Transmission
5. A running gear
6. A steering
7. Brake system
7.1. The design description
7.2. Diagnostics of brake system
7.3. Removal and installation of knots of brake system
7.4. Replacement brake колодок
7.4.1. Replacement of lobbies brake колодок
7.4.2. Replacement back brake колодок
7.5. Repair of knots of brake system
8. Systems of heating, ventilation and air-conditioning
9. A body electric equipment
10. A body
11. Schemes электроборудования
 









7-4-2-zamena-zadnikh-tormoznykh-kolodok.html

7.4.2. Replacement back brake колодок

Removal

Fig. 7.49. The back drum-type brake mechanism: 1 — the union; 2 — a dustproof cap; 3 — the back drum-type mechanism in gathering; 4 — a protective casing of a back brake; 5 — the wheel brake cylinder; 6 — an adjusting lath in gathering; 7 — a lobby brake колодка; 8 — an average coupling spring; 9 — the top coupling spring; 10 — a finger of a keeping spring brake колодки; 11 — back brake колодка; 12 — a keeping spring brake колодки; 13 — a cap of a keeping spring колодки; 14 — the bottom coupling spring; 15 — a nave bolt; 16 — a brake drum




The back drum-type brake mechanism is shown on fig. 7.49.
Remove a brake drum.
Remove a coupling spring in a following order:

Fig. 7.46. An arrangement of the top coupling spring (1), an arm (2) top coupling springs and the bottom coupling spring (3)




- Remove the top coupling spring 1 (fig. 7.46);
- Remove an arm 2 top coupling springs;
- Remove the bottom coupling spring 3;

Fig. 7.47. An arrangement of the adjusting lever (1) and an average coupling spring (2)




- Remove the adjusting lever 1 (fig. 7.47);
- Remove an average coupling spring 2.
Remove brake колодки in a following order:

Fig. 7.48. Removal back brake колодок: 1 — an adjusting lath; 2 — a cap; 3 — a keeping spring brake колодки; 4 — a finger of a keeping spring




- Remove an adjusting lath 1 (fig. 7.48);
-passatizhami turn a finger of a keeping spring brake колодки on 90 ;
- Remove a cap 2 keeping springs brake колодки;
- Remove keeping spring 3;
- Remove a finger 4 keeping springs;

Fig. 7.50. A detachment of a cable of a lay brake from the lever (1) back brake колодки




- Disconnect a cable of a lay brake from the lever 1 (fig. 7.50) back brake колодки and remove back колодку.
Installation
Installation brake колодок spend to sequences, return to removal.
Clear an adjusting lath and put on it greasing.
Connect a cable of a lay brake to the lever back brake колодки.
Establish brake колодки.
Establish an average coupling spring and the adjusting lever.
Establish the bottom coupling spring.
Establish an arm of the top coupling spring.
Establish the top coupling spring.
Establish a brake drum.



To return back
7.4.1. Replacement of lobbies brake колодок
On the following page
7.5. Repair of knots of brake system