4-3-4-remont-vnutrennego-sharnira-vala-privoda.html
4.3.4. Repair of the internal hinge of a shaft of a driveDismantling
|
Fig. 4.140. Use пассатижей J—35566 for removal big (1) and small (2) collars of a protective cover
|
Remove a drive shaft. Using пассатижи J—35566, remove the big and small collars of fastening of a protective cover of the SHRUS ( fig. 4.140).
|
Fig. 4.141. Removal of the case (2) hinges of equal angular speeds from a shaft of a drive and a protective cover (1)
|
Remove the case 2 ( fig. 4.141) the hinge of equal angular speeds from a shaft of a drive and a protective cover 1.
Remove greasing from the hinge.
|
Fig. 4.142. Removal of a spring lock ring (1) and трипоида (2) from a drive shaft
|
Пассатижами remove the spring lock ring fixing трипоид on приводном to a shaft 1 ( fig. 4.142).
Hammer through brass выколотку bring down трипоид from a drive shaft, thus be careful not to damage шлицы a shaft and rollers трипоида.
|
Fig. 4.143. Removal of a protective cover from a drive shaft
|
Remove a protective cover from a drive shaft ( fig. 4.143).
Assemblage
Assemblage of the internal hinge of a shaft of a drive spend to sequences, return to removal.
Wrap up шлицы the internal end of a power shaft a sticky tape not to damage a protective cover from sharp sides шлицов a shaft.
Pull a collar and a protective cover over a power shaft.
Establish трипоид on шлицы a power shaft and fix its lock ring. At assemblage fill the case of the hinge in 90-120 grammes of the recommended greasing.
Fix a protective cover collars, a screw-driver, preliminary having raised internal edge of a cover for alignment of pressure of air under a cover.
|