Daewoo Matiz since 1997 of release
1. The general data
2. Maintenance service
3. The engine
4. Transmission
5. A running gear
6. A steering
7. Brake system
7.1. The design description
7.2. Diagnostics of brake system
7.3. Removal and installation of knots of brake system
7.3.1. Brake hoses
7.3.2. The stoplight switch
7.3.3. A brake pedal
7.3.4. The main brake cylinder
7.3.5. A tank of a brake liquid
7.3.6. A pressure regulator
7.3.7. The gauge of level of a brake liquid
7.3.8. The vacuum amplifier and its hose
7.3.9. A support of a forward brake
7.3.10. A brake disk
7.3.11. A drum of the back brake mechanism
7.3.12. The wheel brake cylinder of the back brake mechanism
7.3.13. A protective casing of a back brake
7.3.14. The lever of a lay brake
7.3.15. A cable of a lay brake
7.4. Replacement brake колодок
7.5. Repair of knots of brake system
8. Systems of heating, ventilation and air-conditioning
9. A body electric equipment
10. A body
11. Schemes электроборудования
 









7-3-1-tormoznye-shlangi.html

7.3.1. Brake hoses

Forward brake hoses
Removal
Remove wheels.
Remove a brake hose in a following order:

Fig. 7.9. Removal of a forward brake hose: 1 — the union; 2 — the E-shaped clamp; 3 — a ring of fastening of a brake hose; 4 — a hollow connecting bolt




- Turn away the union 1 (fig. 7.9);
- Remove the E-shaped clamp 2;
- Disconnect a ring of 3 fastenings of a brake hose from a rack of a forward suspension bracket;
- Turn out a hollow connecting bolt 4;
- Stopper close the open end of a brake tube for prevention of leak of a liquid or its pollution.
Installation
Connect a brake tube to a brake hose and screw the union, having tightened its moment 16 Нм.
Screw a hollow connecting bolt of fastening of a brake hose to a support and tighten its moment 25,5 Нм.
Add a brake liquid.
Pump over brake system.
Check up brake system on absence of leak.
Establish wheels.
Back brake hoses
Removal
Remove back wheels.
Remove a brake hose in a following order:

Fig. 7.10. Removal of a back brake hose: 1 — the union; 2 — the E-shaped lock clamp




- Turn away the union 1 (fig. 7.10);
- Remove the E-shaped lock clamp 2;
- Stopper close the open end of a brake tube for prevention of leak of a liquid or its pollution.
Installation
Connect a brake tube to a brake hose.
Screw the union and establish the E-shaped lock clamp.
Tighten the union the moment 16 Нм.
Add a brake liquid.
Pump over brake system.
Check up brake system on absence of leak.
Establish back wheels.



To return back
7.3. Removal and installation of knots of brake system
On the following page
7.3.2. The stoplight switch