> The vacuum amplifier and its hose. Daewoo Matiz (since 1997 of release)

Daewoo Matiz since 1997 of release
	1. The general data
	2. Maintenance service
	3. The engine
	4. Transmission
	5. A running gear
	6. A steering
	7. Brake system
		7.1. The design description
		7.2. Diagnostics of brake system
		7.3. Removal and installation of knots of brake system
			7.3.1. Brake hoses
			7.3.2. The stoplight switch
			7.3.3. A brake pedal
			7.3.4. The main brake cylinder
			7.3.5. A tank of a brake liquid
			7.3.6. A pressure regulator
			7.3.7. The gauge of level of a brake liquid
			7.3.8. The vacuum amplifier and its hose
			7.3.9. A support of a forward brake
			7.3.10. A brake disk
			7.3.11. A drum of the back brake mechanism
			7.3.12. The wheel brake cylinder of the back brake mechanism
			7.3.13. A protective casing of a back brake
			7.3.14. The lever of a lay brake
			7.3.15. A cable of a lay brake
		7.4. Replacement brake колодок
		7.5. Repair of knots of brake system
	8. Systems of heating, ventilation and air-conditioning
	9. A body electric equipment
	10. A body
	11. Schemes электроборудования

7-3-8-vakuumnyjj-usilitel-i-ego-shlang.html

7.3.8. The vacuum amplifier and its hose

Removal

Remove the main brake cylinder in gathering.

Remove a vacuum hose in a following order:

Fig. 7.21. Places of connection of a vacuum hose to an inlet collector (1) and to the amplifier (2)

- Disconnect a vacuum hose from an inlet collector 1 (fig. 7.21);

- Disconnect a vacuum hose from the amplifier 2.

Fig. 7.22. An arrangement of the unilateral valve in a vacuum hose

Check up the unilateral valve located in a vacuum hose (fig. 7.22).

Remove the vacuum amplifier in a following order:

Fig. 7.23. An arrangement шплинта (1) fixings of a pin (2) with a head

- Unbend шплинт 1 (fig. 7.23) and remove it;

- Remove a pin 2 with a head and an aperture under шплинт;

Fig. 7.24. An arrangement of nuts (1) fastenings of the vacuum amplifier of brakes

- Turn away a nut 1 (fig. 7.24);

Fig. 7.25. A direction of removal of the vacuum amplifier of brakes (1)

- Remove the vacuum amplifier 1 (fig. 7.25).

Installation

Establish the vacuum amplifier, fix nuts and fix шплинтом. Tighten nuts the moment 16 Нм.

The prevention

Be convinced that distance between the amplifier and the centre of a pin of 100 mm.

Connect a vacuum hose to the vacuum amplifier.

Connect a vacuum hose to an inlet collector.

Establish the main brake cylinder in gathering.

Pump over brake system.